Enabling Svp Support; Using The Cli; Show Svp - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide

Enabling SVP Support

Use the CLI or Web management interface to enable SVP support for the access point.

Using the CLI

To enable SVP support on the access point, use the svp command from the CLI configuration mode.
To view the current SVP setting, use the show svp command.
Foundry AP(config)#svp
svp enable
Foundry AP(config)#exit
Foundry AP#show svp
SVP: Enable
Foundry AP#
svp
This command enables SpectraLink Voice Priority (SVP) support on the access point. Use the no
form to disable SVP support.
Syntax
[no] svp
Default
Disabled
Command Mode
Global Configuration
Command Usage
• When enabled, the access point identifies voice traffic by the SpectraLink Radio Protocol
identifier in the IP header of the frame. The system requires support of SVP-enabled VoIP
wireless phones and a SpectraLink NetLink SVP Server on the wired network.
• The number of SVP-enabled wireless phones that can be supported simultaneously by a single
access point has a theoretical limit of seven. However, the practical limit is five, which still allows
some bandwidth for other data traffic.
• SVP support on the access point operates independently from other QoS settings. There is no
need to enable and configure any QoS parameters for SVP to function effectively.

show svp

This command shows the current SVP setting.
Command Mode
Exec
24-6 © 2006 Foundry Networks, Inc. December 2006