Foundry Networks IronPoint 200 User Manual page 150

Foundry IronPoint 200 User Guide
Command Usage
• This command is used in conjunction with the filter ethernet-type protocol command to
determine which Ethernet protocol types are to be filtered.
• Ethernet protocol types not specified in the filtering table are always forwarded by the access
point.
filter ethernet-type protocol
This command sets a specific Ethernet protocol type that is listed in the protocol table to be filtered
from the access point. Use the no form to disable filtering for a specific Ethernet type.
Any traffic that matches the protocol types in the table that have been set to "filter" by this command
are not forwarded by the access point. Other protocol types, either defined in the table or not, are
allowed in and out the access point.
Syntax
filter ethernet-type protocol <protocol>
no filter ethernet-type protocol <protocol>
protocol - An Ethernet protocol type. (Options: Airfortress, Aironet-DDP, Appletalk-ARP, ARP,
Banyan, Berkeley-Trailer-Neg, CDP, Cranite, DEC-LAT, DEC-MOP, DEC-MOP-Dump-Load,
DEC-XNS, EAPOL, Enet-Config-Test, Ethertalk, IP, LAN-Test, NetBEUI, Novell-IPX(new),
Novell-IPX(old), RARP, Telxon-TXP, X25-Level-3)
Default
None
Command Mode
Global Configuration
Command Usage
• Use the filter ethernet-type enable command to enable filtering for Ethernet types specified
in the filtering table, or the no filter ethernet-type enable command to disable all filtering
based on the filtering table.
• Ethernet protocol types not specified in the filtering table are always forwarded by the access
point.
filter ethernet-type dynamic-protocol
This command defines a specific Ethernet protocol type that is not listed in the protocol table to be
filtered from the access point. Use the no form to delete a specific Ethernet type.
Syntax
filter ethernet-type dynamic-protocol <filter-name><protocol-type>
no filter ethernet-type dynamic-protocol <filter-name>
• filter-name - A text name that identifies the filter. (Up to 31 alphanumeric characters.)
• protocol-type - A defined Ethernet protocol type to be filtered from the access point.
(Range: 0x0000 - 0xFFFF)
Default
None
17-4 © 2006 Foundry Networks, Inc. November 2006