Support For Ironpoint Wireless Location Manager - Foundry Networks IronPoint 200 User Manual

Syntax
adc enable
no adc enable
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• Use
adc enable
• Use the
no adc enable
point.
Example
Foundry AP(config)#no adc enable

Support for IronPoint Wireless Location Manager

inline-scanning
If you are using IronPoint Wireless Location Manager, use this command to enable the IronPoint 200
access point to scan for and report neighbor access points.
Syntax
inline-scanning
no inline-scanning
Default Setting
By default, this feature is disabled.
Command Mode
Global Configuration
Command Usage
The purpose of this command is to enable access point to scan more frequently on the current
channel (once every ten minutes) to detect neighbor access points and report them to IronPoint
Wireless Location Manager.
For networks without IronPoint Wireless Location Manager, inline-scanning can be disabled to
eliminate unnecessary scanning of the access points. Use the no form of the command to disable it.
Example
Foundry AP(config)#inline-scanning
December 2006
to enable the ADC feature support on an IronPoint access point.
command to disable the ADC feature support on an IronPoint access
© 2006 Foundry Networks, Inc.
General System and CLI Settings
6-9