Foundry Networks IronPoint 200 User Manual page 189

shutdown command. To view the current 802.11g radio settings, use the show interface wireless
g command (not shown in example).
Foundry AP(config)#interface wireless g
Enter Wireless configuration commands, one per line.
Foundry AP(if-wireless g)#radio-mode g
Foundry AP(if-wireless g)#antenna type 0101
Foundry AP(if-wireless g)#channel 1
Foundry AP(if-wireless g)#speed 54
Foundry AP(if-wireless g)#multicast-data-rate 11
Foundry AP(if-wireless g)#beacon-interval 150
Foundry AP(if-wireless g)#dtim-period 5
Foundry AP(if-wireless g)#fragmentation-length 512
Foundry AP(if-wireless g)#rts-threshold 256
Foundry AP(if-wireless g)#transmit-power half
Foundry AP(if-wireless g)#preamble long
Foundry AP(if-wireless g)#vap 0
Foundry AP(if-wireless g: VAP[0])#description IP200-VAP0
Foundry AP(if-wireless g: VAP[0])#ssid ironpoint-vap0
Foundry AP(if-wireless g: VAP[0])#association-timeout-interval 20
Foundry AP(if-wireless g: VAP[0])#authentication-timeout-interval 30
Foundry AP(if-wireless g: VAP[0])#max-association 32
Foundry AP(if-wireless g: VAP[0])#hidden-ssid
Foundry AP(if-wireless g: VAP[0])#no shutdown
Foundry AP(if-wireless g: VAP[0])#
If you are configuring Radio b/g to automatically detect channel and transmission power, enter
commands as in the following example:
Foundry AP(config)#inteface wireless g
Foundry AP(if-wireless a)#channel auto
Foundry AP(if-wireless g)#auto-channel-selection-mode-overlap
Foundry AP(if-wireless a)#auto-refresh-rate 30
Foundry AP(if-wireless a)#transmit-power auto
auto-channel-selection-mode-overlap
This command allows the 802.11b/g radio to select any valid channel available, including overlapping and non-
overlapping channels (1, 6, or 11).
Syntax
auto-channel-selection-mode-overlap
no auto-channel-selection-mode-overlap
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless - 802.11b/g)
December 2006 © 2006 Foundry Networks, Inc.
Radio Interface Configuration
20-19