Call-In/Call-Out Setup Menu - IBM P 615 series Service Manual

LANGUAGE SELECTION MENU
1. English
2. Francais
3. Deutsch
4. Italiano
5. Espanol
98. Return to Previous Menu
99. Exit from Menus
0>
Note: Your virtual terminal window must support the ISO-8859 character set to correctly display
languages other than English.

Call-In/Call-Out Setup Menu

Note: The information in this section regarding the configuring of serial ports, and modems attached to
those serial ports, applies only to the serial ports (S1 and S2) on the system backplane (location
U0.1-P1). These serial ports are normally used for call-in and call-out.
The call-out function is normally handled by the Service Focal Point application running on the
HMC.
None of these menus are applicable to the serial ports, or modems attached to those serial ports, on the
HMC.
Call-in/call-out is not available on serial port 1 when the system is connected to and HMC and a virtual
terminal window is open providing a connection to the managed system.
CALL-IN/CALL-OUT SETUP MENU
1. Modem Configuration Menu
2. Serial Port Selection Menu
3. Serial Port Speed Setup Menu
4. Telephone Number Setup Menu
5. Call-Out Policy Setup Menu
6. Customer Account Setup Menu
7. Call-Out Test
NOT supported in LPAR mode
98. Return to Previous Menu
99. Exit from Menus
0>
v Modem Configuration Menu, see "Modem Configuration Menu" on page 245.
v Serial Port Selection Menu, see "Serial Port Selection Menu" on page 245.
v Serial Port Speed Setup Menu, see "Serial Port Speed Setup Menu" on page 246.
244 EserverpSeries 615 Service Guide