Call-In/Call-Out Setup Menu - IBM Eserver pSeries 670 User Manual

Call-In/Call-Out Setup Menu

Note: The information in this section regarding the configuring of serial ports, and
1. Modem Configuration Menu
2. Serial Port Selection Menu
3. Serial Port Speed Setup Menu
4. Telephone Number Setup Menu
5. Call-Out Policy Setup Menu
6. Customer Account Setup Menu
7. Call-Out Test
Not supported in LPAR mode
98. Return to Previous Menu
99. Exit from Menus
0>
v Modem Configuration Menu, see "Modem Configuration Menu" on page 37.
v Serial Port Selection Menu, see "Serial Port Selection Menu" on page 38.
v Serial Port Speed Setup Menu, see "Serial Port Speed Setup Menu" on page 39.
v Telephone Number Setup Menu, see "Telephone Number Setup Menu" on page 40.
v Call-Out Policy Setup Menu, see "Call-Out Policy Setup Menu" on page 42.
v Customer Account Setup Menu, see "Customer Account Setup Menu" on page 43.
v Call-Out Test tests the configuration after the modem is installed and configured
correctly.
Note: If the system is running in partition mode, the call-out option is disabled.
Eserver pSeries 670 User's Guide
36
modems attached to those serial ports, applies only to the serial ports (S1 and
S2) on the primary I/O book (location U1.18-P1-H2). These serial ports are
normally used for call-in and call-out.
Call-out is disabled in partitioned systems. The call-out function is normally
handled by the Service Focal Point running application on the HMC.
None of these menus are applicable to the serial ports, or modems attached to
those serial ports, on the hardware management console (HMC).
CALL-IN/CALL-OUT SETUP MENU