Bad Symbol Message - Microscan MS-3 User Manual

Bad Symbol Message

Note: Bad Symbol Message does not apply to multisymbol operations.
Usage: Useful in verifying the presence of a symbol that has not been decoded.
Definition: When enabled, a message is sent to the host when a symbol is detected
but not decoded. See
The Bad Symbol output is tied to the transition counter. If during a read
cycle no symbol is decoded and the required setting for the Transition
Sample Threshold is met, a user defined message will be sent to the
host. See
Bad Symbol Status
Serial Cmd: <K715,bad symbol
Default: Disabled
Options: 0 = Disabled

Bad Symbol Message

Serial Cmd: <K715,bad symbol
Default: BADCODE
Options: Up to 10 ASCII characters (except NUL)
The Bad Symbol output is tied to the transition counter. If during a read
cycle no symbol is decoded and the required setting for the Transition
Sample Threshold is met, a user defined message will be sent to the
host.
"Transition Counter Threshold" on page 6-8.
"Output Message Flow" on page 9-8.
status,bad symbol message>
1 = Enabled
status,bad symbol
Chapter 6 I/O Parameters
message>
MS-3 Laser Scanner User's Manual
6-9