Microscan MS-3 User Manual page 241

Product Labels i-x
Protocol Commands A-18
Pulldown Menus 2-4
Pulse Width, discrete outputs 6-19
Pulse, discrete outputs 6-20
Q
Quality Output 6-26
R
Range A-30
Range Mode Status 5-16
Read Ranges A-3
Read Rate 1-8
Test Button 6-16
read rate i-viii
Reader Status Requests 11-19
Reads/Trigger Status 6-26
Recall customer default parameters and save
for power-on 11-16, A-20
Recall factory default parameters and save
for power-on 11-16, A-20
Receiving 2-13
Request All Master Symbols Data 7-10
Request Master Symbol Data 7-10
Reset 8-6, 11-16, A-20
Reset and recall customer default parameters
11-16
Reset and recall factory defaults 11-16, A-20
Reset and recall power-on parameters 11-16,
A-20
Resolution 8-9
RS-232 A-32
RS-232/422 3-4
RS-232/422 Status 3-10
RS-422 A-32
RS-485 A-32
S
Safety Certifications A-3
Save Calibration Settings 1-10
Save current settings as customer default pa-
rameters 11-16, A-20
MS-3 Laser Scanner User's Manual User's Manual
Save current settings for power-on 11-16,
A-20
Save for Power-on
Test Button 6-16
Saving 2-13, 11-16, A-20
Scan Rate A-30
Scan rate A-2
Scan Speed 4-17
Scan Width A-2, A-30
Scan Width Enhance 4-20
Scanner Connector (15-pin), IB-131 A-9
Scanner Setup 4-17
Scanner Status Byte 11-19
Scanning Performance A-2
Select Sequence A-36
Send/Receive Options 2-13
Separator Character
EAN-128 5-10
UPC/EAN 5-23
Separator Status
UPC/EAN 5-23
Separator, Quality Output 6-26
Sequence On Every Mismatch 7-8
Sequence On Noread, Matchcode 7-7
Sequential Matching, Matchcode 7-4
Serial Command Beep 6-14
Serial Command Echo 6-13
Serial Command Format A-16
Serial Command Status Request A-17
Serial Commands, concatenating A-17
Serial Configuration Commands A-16
Serial Configuration Summary
Communications 3-2
Diagnostics 8-2
I/O Parameters 6-3
Matchcode 7-2
Read Cycle 4-2
Symbology 5-2
Serial Data 4-10
Serial Trigger Character
delimited 4-12
Serial Utility Commands A-16
Serial Verification 6-13
I-5