Microscan MS-3 User Manual page 13

Chapter Chapter
1
1
Step 1 Hardware Required ..........................................................................1-2
Step 2 Connect the System.........................................................................1-3
Step 3 Position Symbol and Scanner ..........................................................1-4
Step 4 Install ESP .......................................................................................1-5
Step 5 Select Scanner Model ......................................................................1-6
Step 6 Autoconnect .....................................................................................1-7
Step 7 Test for Read Rate...........................................................................1-8
Step 8 Calibrate the Scanner ......................................................................1-9
Step 9 Save Calibration Settings for Power-on .........................................1-10
Step 10 Configure the Scanner .................................................................1-11
This section is designed to get the scanner up and running quickly so the user can get a
sense of its capabilities and test sample bar code symbols. Detailed setup information
for configuring the scanner for your specific application can be obtained in the subse-
quent chapters.
Quick Start
Chapter Contents
MS-3 Laser Scanner User's Manual
1-1