Summary Of Utilities Commands; Table 11-2-Utilities Commands - Microscan MS-3 User Manual

Summary of Utilities Commands

Command Type
Read Rate
Counter Request
and Clear
<K224,
ter symbols>
<K231,
number,data>
<Gmaster symbol num-
Matchcode
<K231,
<K231,
Part Number/
Checksum
<K500>
Device Control
<K501>
Table 11-2 Utilities Commands
Command
<Cp> Enter Single Symbol Percent Rate Test
<C> Enter Single Symbol Decode Rate Test
<J> Exit Decode Rate and Percent Rate Test
<N> Noread Counter
<O> Noread Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
<V> Good Read/Match Counter
<W> Good Read/Match Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
<E> Enable Matchcode (see also <K223,...> on
<F> Disable Matchcode (see also <K223,...> on
number of mas- Set master symbol database size.
Also
<)data)> Enter symbol data as master symbol #1.
master symbol Enter symbol data to specified master symbol.
Also <Mmaster symbol number
<G> Store next symbol scanned as master symbol #1.
Store next symbol scanned as specified master symbol.
ber>
<)> Request master symbol #1.
Request all master symbol information.
<K231, ?>
Also
master symbol Request specified master symbol information.
number?> Also
master symbol Delete specified master symbol.
number,> Also <Mmaster symbol number
<))> Delete Master Symbol # 1
<K225,status> Enable/disable New master pin
<!> Display Checksums of EPROM Flash memory
<!b> Display Checksum for Boot Code
<!a> Display Checksum for Application Code
<#> Display Part Numbers
<#b> Display Boot Code Part Number
<#a> Display Application Code Part Number
<H> Enable Laser Scanning
<I> Disable Laser Scanning
or <KE> Motor On
or <KF> Motor Off
<L1> Programmable Output 1
<L2> Programmable Output 2
<L3> Programmable Output 3
Name
<KM number of master symbols>
<M?>
<M#?>
MS-3 Laser Scanner User's Manual
Chapter 11 Utilities
page 7-4.)
page 7-4.)
,
data>
,
>
11-3