Microscan MS-3 User Manual page 11

Warning and Caution Summary
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy, and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
For connection to a UL Listed direct plug-in power unit marked Class 2 and rated at
5 VDC at 2 Amps or greater.
European models must use a similarly rated Class I or Class II power supply that is cer-
tified to comply with standard for safety EN 60950.
Use of controls, adjustments, or performance of procedures other than those specified
herein may result in hazardous laser light radiation exposure.
There are no user serviceable parts in the scanner. Opening the scanner voids the Micros-
can Systems warranty and could expose the user to laser diode power of up to 7 mW.
The laser beam can be harmful to eyesight. Avoid eye contact with the laser beam.
Never point the beam at other people, or in a direction where people may be passing.
WARNING
WARNING
WARNING
MS-3 Laser Scanner User's Manual
xi