Microscan MS-3 User Manual page 163

Chapter 9 Calibration
4. Exit the Calibration Setup menu.
To exit the Calibration Setup menu, press the ESC key. The following prompt
will be displayed:
"DO YOU WANT TO USE CALIBRATION SETTINGS? (NOT SAVED) Y/N."
Typing Y will cause the current settings in the Calibration Setup menu will cause
the scanner to be reset without saving the settings for power-on.
You will then be asked,
DO YOU WANT TO SAVE THESE SETTINGS FOR POWER-ON? Y/N
These settings include Motor Speed, Gain, AGC Level, Laser Power and Laser
Frame.
Typing N will cause the scanner to be reset without saving the settings for power-
on.
MS-3 Laser Scanner User's Manual
9-5