Daisy Chain Id - Microscan MS-3 User Manual

Daisy Chain ID Status
Usage: Used in a daisy chain setup in cases where the host needs to know which
scanner in a daisy chain setup sent the data.
Definition: Each scanner in a daisy chain can be assigned a one or two character ID
that will appear in front of decoded data and identify its source.
Serial Cmd: <K101,aux port mode,baud rate,parity,stop bits,data
ID status,daisy chain ID>
Default: Disabled
Options: 0 = Disabled
Note: Enable/disable and length must be the same in all scanners.

Daisy Chain ID

Usage: Used in a daisy chain setup in cases where the host needs to know which
scanner sent the data.
Definition: A one or two character prefix which identifies the particular daisy chain
scanner from which the data is being sent.
Serial Cmd: <K101,aux port mode,baud rate,parity,stop bits,data bits,daisy chain ID
status,daisy chain
Default: 1/
Options: Any one or two ASCII characters.
1 = Enabled
ID>
MS-3 Laser Scanner User's Manual
Chapter 3 Communications
bits,daisy chain
3-19