Adjustment Of The Finisher (Mj-1022) - Toshiba e-STUDIO350 Service Handbook

3.12 Adjustment of the Finisher (MJ-1022)

Note: Note:
Before performing each adjustment, make sure that all covers (incl. those of the finisher and host
machine) are closed. Otherwise, the power is not supplied to the finisher and the adjustment may
not be performed properly.
3.12.1 Adjusting the jogging plate width
(1) Remove the right inner cover and the rear cover.
(2) Adjust the front jogging plate to the home position.
• Set SW1 on the finisher controller PC board as shown in Fig. 3-114.
• Press SW2 twice on the finisher controller PC board.
- The front jogging plate moves to the home position.
(3) Adjust the rear jogging plate to the home position.
• Set SW1 on the finisher controller PC board as shown in Fig. 3-115.
• Press SW2 twice on the finisher controller PC board.
- The rear jogging plate moves to the home position.
(4) Measure the jogging width (standard at 317 mm).
(5) Remove the processing tray.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ON
1 2 3 4 5
Fig. 3-114
ON
1 2 3 4 5
Fig. 3-115
Rear jogging plate home position
Fig. 3-116
3 - 83
06/09
6 7 8
6 7 8
e-STUDIO350/352/353/450/452/453
3
ADJUSTMENT