Toshiba e-STUDIO350 Service Handbook page 472

[EA21] Paper size error jam
MJ-1101
Is there any paper remaining on the transport path in the finisher or equipment?
YES Remove the paper.
NO
Is the paper size used shorter than the size specified in the specifications?
YES Use the paper size specified in the specifications.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the entrance
sensor (S1)?
Is there a disconnection of the connector, incorrect installation or breakage of the transport
sensor (S2)?
l YES •
l
•
•
NO
Is the harness between the entrance motor (M1) and the finisher control PC board (CN7) dis-
connected or open circuited?
Is the harness between the transport sensor (S2) and the finisher control PC board (CN22)
disconnected or open circuited?
l YES •
•
NO
Replace the finisher control PC board.
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
Connect the connector securely.
Reinstall the sensor correctly.
Replace the sensor.
Reconnect the connector securely.
Replace the harness.
5 - 36
06/01
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved