Toshiba e-STUDIO350 Service Handbook page 385

(9) Press SW1 on the saddle stitcher controller PC board.
• The saddle stitcher unit will "stitch" the sheets, and fold and deliver the stack automatically.
(10) Measure the distance (L) between the stitching position and the folding position. Then perform
"positive width adjustment" or "negative width adjustment" to suit the relationship between the
stitching position and the folding position.
• If the stitching position is below the folding position, perform "positive width adjustment."
• If the stitching position is above the folding position, perform "negative width adjustment."
Positive Width Adjustment
Unit: mm
Example: If L is 1 mm, provide "+1 mm".
(11) Change the settings of bits 6 through 8 on SW504 referring to the following table.
• If the width adjustment is 0
The stitching position and the folding position match, requiring no change.
• If for "positive width adjustment"
Set SW504 so that the difference resulting from subtraction of the interval from the appropri-
ate setting in the table below is provided.
Example: If SW504 is currently set to +2 and the interval is +1 mm, set SW504 to reflect - 2.
• If for "negative width adjustment"
Set SW504 so that the sum resulting from addition of the interval from the appropriate setting
in the table below is provided.
Example: If SW504 is currently set to -1 and the interval is -0.5mm, set SW504 to reflect +1.
Bit 6
OFF
OFF
OFF
OFF
ON
ON
ON
(12) Set SW504 bits 1 to 4 to OFF.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Mark
Folding position
Stitching position
DIPSW1 bit settings
Bit 7 Bit 8
ON ON
ON OFF
OFF ON
OFF OFF
OFF ON
ON OFF
ON ON
Do not use the following setting
Bit 6 Bit 7
ON OFF
3 - 97
Negative Width Adjustment
Unit: mm
Example: If L is 0.5 mm, provide "-0.5 mm".
Setting
(in units of 0.5 mm)
+3
+2
+1
0
-1
-2
-3
Bit 8
OFF
e-STUDIO350/352/353/450/452/453
Mark
Stitching position
Folding position
ADJUSTMENT
3