Toshiba e-STUDIO350 Service Handbook page 13

Paper feeding ....................... Automatic feeding:
Capacity of originals in the reversing automatic document feeder (Option)
.................................................. A3 to A5-R, LD to ST-R:
Automatic duplexing unit ...... Stackless, Switchback type
Toner supply ......................... Automatic toner density detection/supply
Density control...................... Automatic density mode and manual density mode selectable in 11
Weight .................................. 83 kg, 183 lb. (e-STUDIO350/450)
Power requirements ............. AC 110 V (±10%) / 13.2 A, 115 V (±10%) or 127 V (±10%) / 12 A
Power consumption.............. 1.5 kW or less (100 V series), 17 kW or less (200 V series)
* The electric power is supplied to the RADF, Finisher, PFP and LCF through the equipment.
Total counter......................... Electronical counter
Dimensions of the equipment See the figure below
When the tilt angle of the control panel is 45 degrees.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Standard drawers–2 drawers (stack height 60.5 mm, equivalent to 550
sheets; 64 to 80 g/m2 (17 to 22 lb.))
PFP–Option (One drawer or two: stack height 60.5 mm, equivalent to
550 sheets; 64 to 80 g/m2 (17 to 22 lb.))
LCF–Option (Stack height 137.5 mm x 2: equivalent to 2500 sheets; 64
to 80 g/m2 (17 to 22 lb.))
Bypass feeding:
(Stack height 11 mm: equivalent to 100 sheets; 64 to 80 g/m (17 to 22
lb.))
2
100 sheets / 80 g/m (Stack height 16 mm or less)
Toner cartridge replacing method
steps
86 kg, 189.59 lb. (e-STUDIO352/353/452/453)
220-240 V (±10%) or 240 V (±10%) / 8 A
W660 x D718 x H739 mm (e-STUDIO350/450)
W660 x D758 x H739 mm (e-STUDIO352/353/452/453)
H
Fig. 1-1
1 - 3
07/11
D
45˚
W
e-STUDIO350/352/353/450/452/453
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1