Toshiba e-STUDIO350 Service Handbook page 85

Procedure 7
[0][5] [Digital key]
(Code)
[POWER]
*[CANCEL] or [CLEAR]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 17
[CANCEL] or [CLEAR]
[0][5]
[Digital key] [START]
[POWER]
(Code)
Manual
adjustment
[CANCEL] or [CLEAR]
* When the "storing" is not performed within 2 minutes after pressing the [START] button
at the manual adjustment, the "automatic adjustment" starts automatically.
Note: Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state. Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjust-
ment mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes
after it has become ready state and then start up the adjustment mode again.
Test print pattern in Adjustment Mode (05)
Operation:
One test print is printed out when the [FAX] button is pressed after the code is keyed in at Standby
Screen.
Code Types of test pattern
1 Grid pattern
3 Grid pattern (Duplex printing)
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[CANCEL]
( Automatic
[START]
adjustment
[Digital key]
[START] [START]
(Sub code)
[SET] or [INTERRUPT]
(Value unchangeable)
[UP]
Automatic
or
adjustment
[DOWN]
(Adjust a value)
[UP]
or
[DOWN]
(Adjust a value)
2 - 65
05/12
[ENTER]
)
([FAX])
Stores value
( )
(Test copy)
in RAM
Value
( )
displayed
[ENTER]
([FAX])
or
(Test copy)
[INTERRUPT]
Stores value
in RAM
[ENTER]
or
[INTERRUPT]
Stores value
in RAM
Remarks
Refer to P. 3-7 "3.2.3 Printer related adjustment"
Refer to P. 3-7 "3.2.3 Printer related adjustment"
e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
[POWER]
OFF/ON
(Exit)
[POWER]
[START] OFF/ON
(Exit)
[POWER]
OFF/ON
(Exit)
2