Stopping Position Adjustment (Mj-6101:Puncher Unit) - Toshiba e-STUDIO350 Service Handbook

3.14.4

Stopping Position Adjustment (MJ-6101:Puncher unit)

This adjustment can change the position where paper transport stops during the punching operation.
Perform this adjustment when you adjust the punching position on the paper in the transporting direc-
tion.
(1) Turn the power of the equipment OFF.
(2) Take off the board access cover of the Finisher. Then set SW1 (DIP-SW) on the finisher control
PC board as shown below.
(3) Turn the power of the equipment ON. The finisher enters into the stopping position adjustment
mode.
(4) LED1 on the finisher control panel blinks. The number of times it blinks indicates the current
adjustment value.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SW1
ON
1
Fig. 3-147
3 - 107
06/09
2 3 4
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3