Toshiba e-STUDIO350 Service Handbook page 23

Error code Classification
E3E0 Paper transport jam
E400 Cover open jam
E410
E420
E430
E440
E450
E480
E490
E491
E510 Paper transport jam
(ADU section)
E520
E550 Other paper jam
E711 RADF jam
E712
E713
E714
E721
E722
E723
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Contents
LCF transport jam (Paper not reaching the lower
drawer feed sensor): The paper does not reach the
lower drawer feed sensor after it has passed the
LCF feed sensor.
Jam access cover open jam: The jam access cover
has opened during printing.
Front cover open jam: The front cover has opened
during printing.
PFP side cover open jam: The PFP side cover has
opened during printing.
The ADU has opened during printing.
Side cover open jam: The side cover has opened
during printing.
LCF side cover open jam: The LCF side cover has
opened during printing.
Bridge unit open jam: The bridge unit has opened
during printing.
Job separator cover open jam: The job separator
cover has opened during printing.
Offset tray cover open jam: The offset tray cover
has opened during printing.
Stop jam in the ADU: The paper does not reach the
ADU exit sensor after it has passed the ADU
entrance sensor.
Jam not reaching the ADU entrance sensor: The
paper does not reach the ADU entrance sensor
after it is switchbacked in the exit section.
Paper remaining jam on the transport path: The
paper is remaining on the transport path when print-
ing is finished (caused by a multiple paper feeding).
Jam not reaching the original length sensor: The
original fed from the original feeding tray does not
reach the original length sensor.
Jam not reaching the registration sensor: The origi-
nal fed from the original feeding tray does not reach
the registration sensor.
Stop jam at the original length sensor: The trailing
edge of the original does not pass the original
length sensor after its leading edge has reached
this sensor.
Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
Jam not reaching the exit sensor (during scanning):
The original which passed the read sensor does not
reach the exit sensor when it is transported from the
scanning section to exit section.
Jam not reaching the reverse sensor (during scan-
ning): The original which passed the read sensor
does not reach the reverse sensor when it is trans-
ported from the scanning section to reverse section.
2 - 3
Troubleshooting
P. 5-5
P. 5-21
P. 5-21
P. 5-22
P. 5-22
P. 5-23
P. 5-23
P. 5-24
P. 5-24
P. 5-25
P. 5-7
P. 5-8
P. 5-9
P. 5-26
P. 5-26
P. 5-26
P. 5-26
P. 5-27
P. 5-27
P. 5-27
e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
2