Toshiba e-STUDIO350 Service Handbook page 470

MJ-1101
Is there any paper remaining on the transport path in the finisher or equipment?
YES Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the entrance
sensor (S1)?
l YES •
l
•
•
NO
Is the gap between the flapper and entrance roller shaft other than 0.60±0.20mm when the
gate solenoid (SOL2) is pulled?
YES Adjust the gap.
NO
Is the harness between the entrance motor (M1) and the finisher control PC board (CN7) dis-
connected or open circuited?
Is the harness between the gate solenoid (SOL2) and the finisher control PC board (CN22)
disconnected or open circuited?
l YES •
•
NO
Replace the finisher controller PC board.
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
Reconnect the connector securely.
Reinstall the sensor correctly.
Replace the sensor.
Reconnect the connector securely.
Replace the harness.
5 - 34
06/01
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved