Toshiba e-STUDIO350 Service Handbook page 30

Error code Classification
CBF0 Finisher related
service call
CC00
CC10
CC20
CC30
CC31
CC40
CC41
CC50
CC51
CC52
CC60
CC61
CC71
CC72
e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Paper positioning plate motor abnormality: Paper
positioning plate motor is not rotating or paper posi-
tioning plate is not moving normally. [MJ-1024]
Sensor connector abnormality: Connector of guide
home position sensor, paper pushing plate home
position sensor or paper pushing plate top position
sensor is disconnected. [MJ- 1024]
Micro switch abnormality: With all covers closed,
inlet door switch, delivery door switch or front cover
switch is open. [MJ-1024]
Communication error between finisher and saddle
stitcher: Communication error between finisher con-
troller board and saddle stitcher controller board
[MJ-1023/1024]
Stack processing motor abnormality: The stack pro-
cessing motor is not rotating or the stack delivery
belt is not moving normally. [MJ-1022]
Stack transport motor abnormality: The stack trans-
port motor is not rotating or the stack transport belt
is not moving normally. [MJ-1101]
Transport motor abnormality: The transport motor is
not rotating or the stack transport roller -1 and -2 is
not rotating normally. [MJ-1101]
Swing motor abnormality: Swing motor is not rotat-
ing or swing unit is not moving normally. [MJ-1023/
1024]
Paper holder cam home position abnormality: The
paper holder cam is not at the home position. [MJ-
1101]
Horizontal registration motor abnormality: Horizon-
tal registration motor is not rotating or puncher is
not shifting normally. [MJ-1023/1024 (when MJ-
6004 is installed)]
Sideways adjustment motor (M2) abnormality:
Sideways adjustment motor is not rotating or
puncher is not shifting normally. [MJ-1101 (when
MJ-6101 is installed)
Skew adjustment motor (M1) abnormality: Skew
adjustment motor is not rotating or puncher is not
shifting normally. [MJ-1101 (when MJ-6101 is
installed)]
Punch motor abnormality: Punch motor is not rotat-
ing or puncher is not shifting normally. [MJ-1023/
1024 (when MJ-6004 is installed)]
Punch motor (M3) home position detection error:
Punch motor is not rotating or puncher is not shift-
ing normally. [MJ-1101 (when MJ-6101 is installed)]
Punch ROM checksum error: Abnormality of check-
sum value on Hole punch controller PC board is
detected when the power is turned on. [MJ-1101
(when MJ-6101 is installed)]
Punch RAM read/write error: Abnormality of check-
sum value on Hole punch controller PC board is
detected when the power is turned on. [MJ-1101
(when MJ-6101 is installed)]
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
2 - 10
06/01
Troubleshooting
P. 5-78
P. 5-79
P. 5-79
P. 5-79
P. 5-80
P. 5-81
P. 5-81
P. 5-82
P. 5-82
P. 5-82
P. 5-83
P. 5-83
P. 5-84
P. 5-84
P. 5-84