Toshiba e-STUDIO350 Service Handbook page 634

<Updating Finisher ROM (MJ-1023/ 1024)>
Finisher firmware (MJ-1023/1024) and saddle stitcher firmware (MJ-1024 only) are written on the fin-
isher ROM. These two kinds of firmware can be updated individually by installing the download jig to
the finisher control PC board.
Tip:
The following updates are needed according to the finisher model.
• MJ-1023 (Console type):
Only the update of "Finisher firmware" is needed.
• MJ-1024 (Console type with the saddle stitcher):
Two kinds of update "Finisher firmware" and "Saddle stitcher firmware" are needed.
(1) Install the ROM to the download jig.
Make sure the direction is correct (P. 6-35 "Fig. 6-29").
(2) Shut down the equipment.
(3) Take off the finisher rear cover.
Finisher rear cover
Fig. 6-54
[MJ-1023]
* Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
(5) Change the setting of the DIP switch on the finisher control PC board.
Change the setting of the DIP switch as follows according to the firmware to be updated.
e-STUDIO350/352/353/450/452/453
FIRMWARE UPDATING
Connector
Fig. 6-56
6 - 58
05/11
Finisher rear cover
Fig. 6-55
[MJ-1024]
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved