[EA31] Transport path paper remaining jam
MJ-1101
Is there any paper remaining on the transport path in the finisher or equipment?
YES
Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the transport
sensor (S2)?
l
YES
•
l
•
•
NO
Is the harness between the transport sensor (S2) and the finisher control PC board (CN22)
disconnected or open circuited?
l
YES
•
•
NO
Replace the finisher control PC board.
[EA32] Exit paper remaining jam
MJ-1101
Is there any paper remaining on the transport path in the finisher or equipment?
YES
NO
Is there a disconnection of the connector, incorrect installation or breakage of the finishing tray
paper detection sensor (S12)?
l
YES
l
NO
Is the harness between the finishing tray paper detection sensor (S12) and the finisher control
PC board (CN11) disconnected or open circuited?
l
YES
NO
Replace the finisher control PC board.
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
Connect the connector securely.
Reinstall the sensor correctly.
Replace the sensor.
Reconnect the connector securely.
Replace the harness.
Remove the paper.
•
Connect the connector securely.
•
Reinstall the sensor correctly.
•
Replace the sensor.
•
Reconnect the connector securely.
•
Replace the harness.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 38
06/01