Toshiba e-STUDIO350 Service Handbook page 659

(8) "Update Completed." is displayed at the bottom of the LCD screen after the updating is com-
pleted properly.
Tip:
Updating can be continued with another USB storage device on which the firmware data is writ-
ten in the following procedure when the updating is completed.
a. Confirm the message "Please Connect Next Storage Key. Push 'START' Button!!" is displayed
at the bottom of the LCD screen.
b. Replace the USB storage device while the power is left ON.
c. Press the [START] button.
d. The screen for selecting the items to be updated is displayed. Continue the updating from
procedure (6). However, the items already updated are not displayed on the screen.
"Update Failed." is displayed at the bottom of the LCD screen when the updating is not com-
pleted properly. Turn OFF the power, and then check the following items. After confirming and
clearing the problems, restart updating from the beginning.
• Does the USB storage device meet the conditions to be used for updating (P. 6-79)?
• Is the data file written properly on the USB storage device?
• Is the USB storage device installed properly?
• Do the USB storage device and equipment operate properly?
* When the updating of the NIC firmware is failed, an error message is displayed as the figure
below. Turn OFF the power and then check the above-mentioned items. After confirming
them, select only "4. NIC Firmware Update" and restart updating from the beginning. This
may complete the updating properly.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 83
04/10
e-STUDIO350/352/353/450/452/453
FIRMWARE UPDATING
6