Toshiba e-STUDIO350 Service Handbook page 297

[E] Primary scanning data laser writing start position at duplexing
Note: Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[E-1] Adjustment for long-sized paper
While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
Press [3] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower
(2)
drawer.)
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
<Procedure>
(Adjustment Mode) → (Key in code [498]) → [START] → [0] → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed.
→ Press [3] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes. (approx. 0.05 mm/
step)
[E-2] Adjustment for short-sized paper
While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
Press [3] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper
(2)
drawer.)
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 9
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3