Toshiba e-STUDIO350 Service Handbook page 69

Classifi-
Code
cation
340 Scanner Reproduction ratio adjust-
ment of secondary scan-
ning direction
(scanner section)
354 RADF Adjustment of
RADF paper
alignment
355
356 RADF Automatic adjustment of
RADF sensor and
EEPROM initialization
357 RADF Fine adjustment of RADF
transport speed
358 RADF RADF sideways deviation
adjustment
359 Scanner Carriage position adjust-
ment during scanning from
RADF
365 RADF RADF lead-
ing edge posi-
tion
adjustment
366
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Adjustment mode (05) <e-STUDIO350/450>
Func- <Accept-
Items
tion
ALL
for single- ALL
sidedorigi-
nal
for double- ALL
sidedorigi-
nal
ALL
ALL
ALL
ALL
for single ALL
sided orig-
inal
for double ALL
sided orig-
inal
2 - 49
05/10
Default
RAM Contents
able
value>
128 SYS When the value
<0-255> increases by "1", the
reproduction ratio in
the secondary scan-
ning direction (vertical
to paper feeding direc-
tion) increases by
approx. 0.223%.
10 SYS When the value
<0-20> increases by "1", the
aligning amount
increases by approx.
10 SYS
0.5mm.
<0-20>
- SYS Performs the adjust-
ment and initialization
when the RADF board
or RADF sensor is
replaced.
50 SYS When the value
<0-100> increases by "1", the
reproduction ratio of
the secondary scan-
ning direction when
using the RADF
increases by approx.
0.1%.
128 SYS When the value
<0-255> increases by "1", the
image of original fed
from the RADF shifts
toward the rear side of
paper by approx.
0.0846mm.
128 SYS When the value
<0-255> increases by "1", the
carriage position when
using the RADF shifts
by approx. 0.1 mm
toward the original
feeding side.
50 SYS When the value
<0-100> increases by "1", the
copied image of origi-
nal fed from the RADF
50 SYS
shifts toward the trailing
<0-100>
edge of paper by
approx. 0.1mm.
e-STUDIO350/352/353/450/452/453
ERROR CODE AND SELF-DIAGNOSTIC MODE
Pro-
cedur
e
1
2
1
1
6
1
1
1
1
1