Toshiba e-STUDIO350 Service Handbook page 383

(9) After confirming that the staple position is adjusted correctly, place a sheet of paper between the
alignment plates and push it against the stopper and push the rear edge of the paper against the
rear alignment plate. Then press SW103 once. (Stapling is performed and the adjustment value
is stored in memory.)
• The staple position adjustment is completed.
(10) Turn OFF all bits of SW104 on the finisher controller PC board.
(11) Turn OFF the power and install the rear cover of the finisher unit.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 95
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3