(3)
Close the RADF and check if the positioning
pins fit the holes on the RADF.
[B] Adjustment
If the pins cannot be fitted into the holes, perform the adjustment according to the following procedure.
(1)
Remove the right-hand hinge screw at the
rear side.
(2)
Loosen the left-hand hinge screw at the rear
side.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-86
Fig. 3-87
Fig. 3-88
3 - 69
05/11
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3