Pages (E-Studio350/352/353) And 150,000 Output Pages (E-Studio450/452/453)) - Toshiba e-STUDIO350 Service Handbook

4.2 General Descriptions for PM Procedure (Maintenance
Performed Every 120,000 Output Pages (e-STUDIO350/352/
353) and 150,000 Output Pages (e-STUDIO450/452/453))
(1) Preparation
• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the PM support mode (6S-
2) or list printing mode (9S-103).
6S-2 :
9S-103 :
PM SUPPORT CODE LIST
11-10-'03 09:30
UNIT
DRUM
DRUM BLADE
GRID
MAIN CHARGER WIRE
SEPARATION FINGER (DRUM)
• Turn OFF the power and make sure to unplug the equipment.
(2) Perform a preventive maintenance using the following checklist and illustrations. Refer to the
Service Manual if necessary.
(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and
make some copies to confirm that the equipment is working properly.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[6]+[START]+[POWER]ON → [2] Æ [START]
[9]+[START]+[POWER]ON → [103] → [START]
OUTPUT PAGES PM OUTPUT PAGE
81813 150000
81813 150000
81813 150000
81813 150000
81813 150000
Fig. 4-7
4 - 7
07/11
DRIVE COUNTS PM DRIVE COUNTS
119758 220000
119758 220000
119758 220000
119758 220000
119758 220000
e-STUDIO350/352/353/450/452/453
PREVENTIVE MAINTENANCE (PM)
4