Toshiba e-STUDIO350 Service Handbook page 555

11) Skew (inclined image)
Defective area Step
Drawers LCF 1
2
3
4
Feed roller 5
Rollers 6
Registration roller 7
Pre-registration 8
guide
Carriage-1 9
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Check items
Is the drawer or LCF properly
installed?
Is there too much paper in the
drawer or LCF?
Is the corner of the paper folded?
Are the side guides of the drawer or
LCF properly installed?
Is the surface of the feed roller dirty? Clean the roller surface with alcohol, or
Are the roller and shaft secured?
Is the spring detached from the reg-
istration roller?
Is the pre-registration guide properly
installed?
Is the carriage-1 slanted?
5 - 119
05/11
Prescription
Install the drawer or LCF properly.
Reduce paper to 550 sheets or less. (2500
sheets or less/stack for LCF)
Change the direction of the paper and set
it again.
Adjust the position of the side guides.
replace the roller.
Check and tighten the E-rings, pins, clips
and setscrews.
Attach the spring correctly. Clean the roller
if it is dirty.
Correct it.
Adjust the carriage-1.
e-STUDIO350/352/353/450/452/453
TROUBLESHOOTING
5