Toshiba e-STUDIO350 Service Handbook page 307

[G] Right margin
While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
(2) Open platen cover or RADF.
(3) Press [FAX] to make a copy at the mode of A3/LD, 100%, Text/Photo and lower drawer.
(4) Measure the blank area F at the right side of the copied image.
(5) Check if the blank area F is within the range of 2+1 mm, 2-0.5 mm.
(6) If not, use the following procedure to change values and repeat the steps 3. to 5. above.
<Procedure>
(Adjustment Mode) → (Key in the code [432]) ? [START]
→ (Key in a value (acceptable values: 0 to 255))
→ Press the [ENTER] or the [INTERRUPT] button (stored in memory)
→ ("100% A" is displayed.)
* The larger the adjustment value is, the wider the blank area at the right side becomes
(approx. 0.04 mm/step).
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Feeding direction
F
Fig. 3-11
3 - 19
04/05
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3