3.7
Adjustment of the Scanner Section
3.7.1
Carriages
[A] Installing carriage wires
When replacing the carriage wires, refer illustrations below:
[Front side]
Tension spring
Wire pulley
[Rear side]
Idler pulley
Adjustment of the carriage wire tension is not necessary since a certain tension is applied to the car-
riage wires by the tension springs.
Note:
Note:
Make sure the tension applied to the wire is normal.
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
Carriage wire
Bracket for carriage-1
Hook
Fig. 3-32
Carriage-2
Carriage wire
Bracket for carriage-1
Tension spring
Fig. 3-33
3 - 40
Carriage-2
Hook
Wire pulley
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Idler pulley