3.7
Adjustment of the Scanner Section
3.7.1
Adjustment carriages-1 and -2 positions
(1)
Move the carriage-2 toward the exit side.
(2)
Loosen the screws fixing the front side pulley
bracket, make the sections A and B of the
carriage-2 touch with the inside of the exit
side frame and screw them up.
(3)
Put the carriage-1 on the rail, make the
sections C and D of it touch with the inside of
the exit frame and screw up the front/rear
side of the bracket to fix it.
Note:
Make sure that the sections A and B of the
carriage-2 touch with the exit side frame.
e-STUDIO5520C/6520C/6530C
ADJUSTMENT
Carriage-2
[ Rear ]
Exit side frame
B
Bracket
Carriage-1
D
[ Rear ]
Enlarged view of carriage
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 70
Pulley bracket
[Front]
A
Enlarged view of carriage
Fig. 3-30
Bracket
Exit frame
C
[ Front ]
Fig. 3-31