Fip-1. 68 Paper Jam 077-100/077-101 .............................................................................................. 1 - Dell 2135cn Service Manual

FIP-1. 68 Paper Jam 077-100/077-101
Step
Possible causative parts:
ACTUATOR REGI IN (PL3.2.11)
SENSOR PHOTO (PL3.2.13)
HARN ASSY L SIDE (PL10.4.18)
PWBA MCU(PL10.7.7)
Checking the error
1 Replace to known good paper.
Does the error still occur when printing?
Checking the Regi Rolls installation
Open the Front Cover and check the Regi Rolls installation.
2
Is the ROLL REGI METAL pressed against the ROLL ASSY
REGI by the spring pressure?
Checking the Regi Clutch
Does the clutch noise occur?
3
Checked by [REGI CLUTCH Operation Check] of the
[Diagnosis] tab in the [Tool Box].
Checking the Regi Sensor for operation
Does the number on the screen increase by one, when the
4 actuator (ACTUATOR REGI IN) is operated?
Checked by [Digital Input]-[DI-2] of the [IOT Diag] on the
[Printer] of the diagnosis.
Checking the ACTUATOR REGI IN for shape and operation
Remove the CHUTE LOW (PL3.2.27) once to check the
5 shape and operation.
Are the shape and operation of the ACTUATOR REGI IN
normal?
Checking the connectors of the SENSOR PHOTO (Regi
Sensor) for connection
Check the connections between the PWBA MCU and
SENSOR PHOTO.
Are P/J23 and P/J232 connected correctly?
6
Version 2 2008.03.31
Check
1 - 307
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. End of work.
Replace the
Go to step 3.
printer.
Replace the
Go to step 4.
printer.
Replace the
PWBA MCU.
(Refer to Removal Go to step 5.
31/ Replacement
29.)
Reseat the
ACTUATOR REGI
Go to step 6. IN. If broken or
deformed, replace
it.
Reconnect the
connector(s) P/
Go to step 7.
J23 and/or P/J232
correctly.
No