Chapter 3 Removal and Replacement Procedures (RRPs)
Removal 22 SHIELD ASSY ESS (PL10.6.19)
1) Remove the Tray 1. (Removal 1)
2) Open the COVER ASSY FRONT (PL10.2.1).
Note: Cover the drum of the PHD unit to avoid exposure to light.
3) Remove the PHD Unit. (Removal 3)
Note: The FUSER part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the FUSER ASSY. (Removal 9)
5) Remove the COVER ASSY SIDE R. (Removal 10)
6) Remove the COVER ASSY SIDE L. (Removal 14)
7) Remove the COVER POLE OUT. (Removal 15)
8) Remove the COVER ASSY ESS. (Removal 16)
9) Remove the COVER REAR. (Removal 17)
10) Remove the fourteen screws (silver,
6mm) that fix the SHIELD ASSY ESS
(PL10.6.19) to the printer.
11) Lift the SHIELD ASSY ESS slightly up
to release the two tabs of the SHIELD
ASSY ESS, remove the SHIELD ASSY
ESS from the printer.
3 - 43
Version 1
2008.02.01