Dell 2135cn Service Manual page 585

Hide thumbs Also See for 2135cn:

Table of Contents

Chapter 3 Removal and Replacement Procedures (RRPs)

Removal 41 HOLDER ASSY TCRU (K), (C), (M), (Y) (PL5.1.17~20)

1) Remove the Tray 1. (Removal 1)

2) Open the COVER ASSY FRONT (PL10.2.1).

Note: Cover the drum of the PHD unit to avoid exposure to light.

3) Remove the PHD Unit. (Removal 3)

Note: The FUSER part is very hot. Take added care not to get burned when performing the

service operation.

4) Remove the FUSER ASSY. (Removal 9)

5) Remove the COVER ASSY SIDE R. (Removal 10)

6) Remove the COVER ASSY SIDE L. (Removal 14)

7) Remove the COVER POLE OUT. (Removal 15)

8) Remove the COVER ASSY ESS. (Removal 16)

9) Remove the COVER REAR. (Removal 17)

10) Remove the COVER TOP. (Removal 18)

11) Remove the SHIELD ASSY ESS. (Removal 22)

12) Remove the CHASSIS ASSY LVPS. (Removal 28)

13) Remove the COVER SCANNER LOW. (Removal 37)

14) Remove the COVER POLE IN. (Removal 38)

15) Remove the PLATE ASSY DUCT. (Removal 39)

16) Remove the CHASSIS ASSY BREAKER. (Removal 40)

Note: Described below is the removal procedure common among the four HOLDER ASSY

17) Press the central part of the HOLDER

ASSY TCRU to release the hole of the

HOLDER ASSY TCRU from the boss of

the FRAME DISP (PL5.1.12). Open the

HOLDER ASSY TCRU by 90 degrees.

Chapters

Table of Contents