Flows 39 Load Ssf 024-969 / 075-923 Reseat Paper - Dell 2135cn Service Manual

Flows 39 Load SSF 024-969 / 075-923 Reseat paper

When loading a sheet to the SSF, ensure that the lead edge of the sheet touches the
back of the SSF (as far as 8 to 10cm from the lead edge). Otherwise, this error may
occur.
Checking the paper for loading and setting
Check that the loaded paper meets the print job.
Check that the paper setting to require the print job
meets the specification.
Does the error still occur after reloading the paper
and changing the paper settings that requires the
print job?
Checking after reloading a paper to SSF
Reload a correct paper to SSF.
Does the error still occur when printing?
Checking the SSF No Paper Sensor (SENSOR
PHOTO) for operation
Remove the CHUTE LOW (PL3.2.27) once to check
the operation.
Does the number on the screen increase by one,
when the actuator (ACTUATOR SSI) of the SSF No
Paper Sensor (SENSOR PHOTO) is operated?
Checked by [Digital Input]-[DI-0] of [IOT Diag] in
[Printer Diag] of diagnosis.
Version 4 2008.12.22
Yes
Yes
Yes
END
1 - 104
Chapter 1 Troubleshooting
No
END
No
END
No
Replace the PWBA MCU. (Refer to
Removal 31/ Replacement 29.)