Fip-1. 3 Nvm Error 003-356 ............................................................................................................... 1 - Dell 2135cn Service Manual

FIP-1. 3 NVM Error 003-356
If the error occurred after replacing the PWBA MCU, transfer the internal data of the old
PWBA MCU to a new one.
Step
Possible causative parts:
PHD ASSY (PL4.1.21)
TONER CARTRIDGE (K) (PL5.1.21)
TONER CARTRIDGE (C) (PL5.1.22)
TONER CARTRIDGE (M) (PL5.1.23)
TONER CARTRIDGE (Y) (PL5.1.24)
HARN ASSY TONER CRUM (PL5.1.26)
PWBA MCU (PL10.7.7)
PWBA EEPROM (XPRO) (PL10.7.6)
HARN ASSY PHD XPRO (PL10.8.11)
Does the error still occur after several ON/OFF procedures
1
of the power?
Checking after reseating the PHD UNIT and TONER
CARTRIDGEs
2 Reseat the PHD UNIT and four TONER CARTRIDGEs.
Does the error still occur when the power is turned OFF and
ON?
Checking after reseating the PWBA MCU
Reseat the PWBA MCU.
3
Does the error still occur when the power is turned OFF and
ON?
Checking the connectors for connection
Are the following connectors connected correctly?
- P/J311 on the Toner CRUM (Y)
- P/J312 on the Toner CRUM (M)
- P/J313 on the Toner CRUM (C)
- P/J314 on the Toner CRUM (K)
- P/J31 on the PWBA MCU
- P/J42 on the PWBA MCU
- P/J144 on the PWBA EEPROM (XPRO)
- P/J422 on the PHD UNIT
4
P/J314
P/J313
P/J312
P/J311
Does the error still occur when the power is turned OFF and
5
ON?
Version 2 2008.03.31
Check
P/J422
1 - 218
Chapter 1 Troubleshooting
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 6.
P/J42
P/J144
P/J31
Mnt01004KA
Go to step 6.
Remedy
No
End of work. *1
End of work. *1
End of work. *1
Reconnect the
connector(s) P/J
311 to P/J314, P/
J31, P/J42, P/
J144 and/or P/
J422 correctly,
then go to step 5.
End of work.