Fip-1.P10 Afterimage (Ghost) - Dell 2135cn Service Manual

FIP-1.P10 Afterimage (Ghost)

Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the error mode
1
Does the error occur only during copying?
Checking the original
2
Is the original color clean?
Checking the printing
3
Did the client print the same image of large volume?
Checking the Afterimage(Ghost).
4 Print the Windows test page.
Is the image printed correctly?
Checking the Afterimage(Ghost).
Print the [Ghost Configuration Chart] in [Chart Print] in
5
[Diagnosis] tab of [Tool Box].
Is the image printed correctly?
Checking the erase lamps
Open the COVER ASSY FRONT, and remove the PHD
6 UNIT.
Cheat the safety interlock switch.
Does the four erase LEDs light correctly?
Version 3 2008.06.13
Afterimage
Wsb02020KA
Check
Trouble substance
The ghost appears on the paper. The
ghost may be the image of the
previous page, or a part of the page
currently printing.
Possible causative parts
- LED ASSY ERASE (PL4.1.8)
- PHD UNIT (PL4.1.21)
- FUSER ASSY (PL6.1.1)
- TRANSFER ASSY (PL6.1.7)
- PWBA CONT AIO (PL10.6.6)
Mnt01114KA
- PWBA MCU (PL10.7.7)
- HARN ASSY LVPS (PL10.8.3)
Go to step 2.
Go to step 5.
Go to step 4.
Check the printing
data which the
problem
generated.
End of work.
Go to step 10.
1 - 397
Chapter 1 Troubleshooting
Remedy
Yes No
Go to step 3.
Change the
original.
Go to step 5.
Go to step 5.
Go to step 6.
Go to step 7.