Fip-1.P14 Unfusing - Dell 2135cn Service Manual

FIP-1.P14 Unfusing

Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the using paper
1
Does the using paper meet the specifications?
2 Is the image printed correctly?
Checking the paper condition
3
Is the paper dry and recommended paper?
4 Is the image printed correctly?
Checking the Toner Type
5
Is the Dell Toner seated?
6 Is the image printed correctly?
Checking the power cord for connection
Connect the power cord with other wall outlet. (Never
7 connect the power cord into other connector of the same
wall outlet.)
Is the image printed correctly?
Checking after reseating the FUSER ASSY
Warning: Start the operation after the FUSER ASSY has
8 cooled down.
Reseat the FUSER ASSY.
Is the image printed correctly?
Checking after replacing the FUSER ASSY
Warning: Start the operation after the FUSER ASSY has
cooled down.
9
Replace the FUSER ASSY and initialize the Fuser Life
Counter. (Refer to Removal 9/Replacement 51.)
Does the error still occur when printing?
Version 3 2008.06.13
Trouble substance
The printed image is not fixed on the paper properly. The image easily
comes off when rubbed.
Possible causative parts
- FUSER ASSY (PL6.1.1)
- PWBA MCU (PL10.7.7)
Mnt01118KA
Check
Go to step 3.
End of work.
Go to step 5.
End of work.
Go to step 7.
End of work.
End of work.
End of work.
Replace the
PWBA MCU.
(Refer to Removal
31/ Replacement
29.)
1 - 410
Chapter 1 Troubleshooting
Remedy
Yes No
Use the paper that
meets the
specifications,
then go to step 2.
Go to step 3.
Replace the paper
with a new dry and
recommended
one, then go to
step 4.
Go to step 5.
Replace the toner
with Dell Toner,
then go to step 6.
Go to step 7.
Go to step 8.
Go to step 9.
End of work.