Fip-1. 64 Paper Jam 075-100............................................................................................................. 1 - Dell 2135cn Service Manual

FIP-1. 64 Paper Jam 075-100
Step
Possible causative parts:
CLUTCH ASSY DRV (PL3.1.1)
ACTUATOR REGI ROLL (PL3.2.8)
SENSOR PHOTO (PL3.2.13)
ACTUATOR SSI (PL3.2.14)
DRIVE ASSY MAIN (PL7.1.2)
DRIVE ASSY PH (PL7.1.4)
HARN ASSY L SIDE (PL10.4.18)
PWBA MCU (PL10.7.7)
HARN ASSY MAIN MOT (PL10.8.7)
HARN ASSY KSNR REGCL (PL10.8.9)
Checking the paper size
1
Does the using paper size meet the specification?
2 Does the error still occur when printing?
Checking the paper condition
3
Is the paper in the SSF wrinkled or damaged?
4 Does the error still occur when printing?
Checking after reloading a new paper
5 Reload a new paper in the SSF.
Does the error still occur when printing?
Checking the COVER ASSY FRONT for latching
Open and close the COVER ASSY FRONT, and then latch
6
correctly.
Does the error still occur when printing?
Checking the DRIVE ASSY MAIN for operation
Does the ROLL ASSY FEED rotate properly?
Checked by [Digital Output]-[DO-0] of [IOT Diag] in [Printer
7
Diag] of diagnosis.
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK).
Checking the paper lead edge staying position
8 Does the paper lead edge stay before the ROLL ASSY
REGI and ROLL REGI METAL?
Checking after resetting the guide sides of the SSF
9 Reset the side guides.
Does the error still occur when printing?
Checking the paper transfer path between the SSF paper
10 loading window and Regi.Sensor
Are there any obstacles on the paper transfer path?
11 Does the error still occur when printing?
Version 2 2008.03.31
Check
1 - 299
Chapter 1 Troubleshooting
Remedy
Yes
Use the paper that
meets the
Go to step 3.
specifications,
then go to step 2.
Go to step 3. End of work.
Replace the paper
with a new and dry
Go to step 5.
one, then go to
step 4.
Go to step 6. End of work.
Go to step 6. End of work.
Go to step 7. End of work.
Reseat or replace
the DRIVE ASSY
Go to step 8. MAIN. (Refer to
Removal 33/
Replacement 27.)
The paper lead
edge stay after the
ROLL ASSY REGI
Go to step 9.
and ROLL REGI
METAL, then go to
step 14.
Go to step 10. End of work.
Remove the
obstacles or stain
from the paper Go to step 12.
transfer path, then
go to step 11.
Go to step 12. End of work.
No