Dell 2135cn Service Manual page 436

Step
Checking the paper condition
9
Is the paper dry and recommended paper?
10 Is the image printed correctly?
Checking the COVER ASSY FRONT for latching
11 Open and close the COVER ASSY FRONT.
Is the image printed correctly?
12 Is the image printed correctly?
Checking after reseating the PHD UNIT
13 Reseat the PHD UNIT.
Is the image printed correctly?
Checking after reseating the FUSER ASSY
Warning: Start the operation after the FUSER ASSY has
14 cooled down.
Reseat the FUSER ASSY.
Is the image printed correctly?
Checking after reseating the TRANSFER ASSY
15 Reseat the TRANSFER ASSY.
Is the image printed correctly?
Checking the paper feeding tray
16
Is the damaged paper fed from the SSF?
Checking the side guides setting of SSF
17 Reset the side guides.
Is the image printed correctly?
Checking the paper path
18
Are there any foreign substances on the paper path?
19 Is the image printed correctly?
Checking the ROLL ASSY REGI and ROLL REGI METAL
for rotation
Checked by [Digital Output]-[DO-00 and 29] of the [IOT
Diag] on the [Printer] of the diagnosis.
20
Does the ROLL ASSY REGI and ROLL REGI METAL
rotate?
During this check, cheat the interlock switch (HARN ASSY
INTERLOCK).
Checking after reseating the Paper Cassette
21 Reseat the Paper Cassette.
Is the image printed correctly?
Checking the side guides of the Paper Cassette
22 Reset the side guides.
Is the image printed correctly?
Checking after reseating a new paper
23 Reseat a new paper in the Paper Cassette.
Is the image printed correctly?
Checking the paper path
24
Are there any foreign substances on the paper path?
25 Is the image printed correctly?
Version 1 2008.02.01
Check
1 - 408
Chapter 1 Troubleshooting
Remedy
Yes
Replace the paper
with a new dry and
Go to step 11. recommended
one, then go to
step 10.
End of work. Go to step 11.
Replace the
End of work. defective parts,
then go to step 12.
End of work. Go to step 13.
End of work. Go to step 14.
End of work. Go to step 15.
End of work. Go to step 16.
Go to step 17. Go to step 21.
End of work. Go to step 18.
Remove the
foreign
Go to step 20.
substances, then
go to step 19.
End of work. Go to step 20.
Replace the ROLL
ASSY REGI and/
End of work.
or ROLL REGI
METAL.
End of work. Go to step 22.
End of work. Go to step 23.
End of work. Go to step 24.
Remove the
foreign
Go to step 26.
substances, then
go to step 25.
End of work. Go to step 26.
No