Fip-1. 84 Low Density 093-920 .......................................................................................................... 1 - Dell 2135cn Service Manual

FIP-1. 84 Low Density 093-920
Step
Possible causative parts:
PHD UNIT (PL4.1.21)
DISPENSER ASSY (PL5.1.1)
FRAME ASSY MOT (PL5.1.2)
MOTOR ASSY DISP (PL5.1.3)
GEAR IDLER (PL5.1.6)
GEAR IDLER AUG (PL5.1.7)
GEAR IDLER AGI (PL5.1.8)
TONER CARTRIDGE (M) (PL5.1.23)
HARN ASSY TNR MOT (PL5.1.25)
TRANSFER ASSY (PL6.1.7)
PWBA MCU (PL10.7.7)
Checking the Toner Type
1
Is the Dell Toner seated?
Checking the sealing tapes on the PHD UNIT staying
Are there sealing tapes on the PHD UNIT?
2
Checking the life count value of the TONER CARTRIDGE
(M)
Check the life count value of the TONER CARTRIDGE (M)
3 In [Parameter]-[Life M Toner of [IOT Diag] in [Printer Diag] of
diagnosis.
Does the remainder value shows the near of the end?
(Refer to Chapter 2 for details of the life counter value.)
Does the error still occur when the power is turned OFF and
4
ON?
Checking the toner remainder in the Non-Dell Toner
Cartridge (M)
5
Is the toner that remains in the Non-Dell Toner Cartridge (M)
a little?
Does the error still occur when the power is turned OFF and
6
ON?
Checking the sealing tapes for magenta toner of the PHD
UNIT staying
Turn off the power, and open the COVER ASSY FRONT.
7
Remove the PHD UNIT.
Has the sealing tapes for magenta toner been pulled out?
After checking, reseat the PHD UNIT.
Does the error still occur when the power is turned OFF and
8
ON?
Version 1 2008.02.01
Check
1 - 333
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. Go to step 5.
Pull the tape out. Go to step 3.
Replace the
TONER
CARTRIDGE (M),
then go to step 4. Go to step 7.
(Refer to Removal
7/ Replacement
53.)
Go to step 7. End of work.
Replace the Non-
Dell Toner
Go to step 7.
Cartridge (M),
then go to step 6.
Go to step 7. End of work.
Pull the sealing
Go to step 9. tapes out, then go
to step 8.
Go to step 9. End of work.
No