Dell 2135cn Service Manual page 575

Chapter 3 Removal and Replacement Procedures (RRPs)
18) Remove the SPRING FEED OUT
(PL10.4.15) from the printer.
19) Release the hook of the GEAR ASSY
FEED (PL10.4.19), remove the GEAR
ASSY FEED from the SHAFT ASSY FEED
(PL3.2.2).
When carrying out the work this
procedure, pushing down the LEVER
FEED (PL10.4.13).
20) Release the HARNESS A-OP-OPP
(PL10.2.13) from the hooks of the printer,
release the harness of the SOLENOID
FEED MSI (PL10.4.11) from the hooks of
the printer.
Note: When carrying out the work described next procedure, leave the relay connector on the
printer harness side.
3 - 73
Version 1 2008.02.01