Fip-1.P13 Paper Damage - Dell 2135cn Service Manual

FIP-1.P13 Paper damage

Mnt01117KA
.Tray is recommended for paper feeding because sheets fed via SSF is prone to
skew depending on how the sheet is placed on SSF.
Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the error mode
1
Does the error occur when feeding the original at the ADF?
Checking the original
2
Does the original meet the ADF spec.?
Checking the ADF Guides setting
3 Reseat the ADF Guides.
Does the error still occur when copying?
Checking the ADF Feed Roller and the Separator Pad
4 Are there any damages or foreign substances on the Roller
and Pad?
Checking dew condensation
5 Was the printer installed in the room where the air
conditioner well works?
6 Is the image printed correctly?
Checking the using paper
7
Does the using paper meet the specifications?
8 Is the image printed correctly?
Version 1 2008.02.01
Trouble substance
The paper comes out from the printer wrinkled, folded or worn-out.
Possible causative parts
- SEPARATOR ROLLER ASSEMBLY (PL2.1.5)
- ROLL ASSY FEED (PL3.2.4)
- ROLL ASSY REGI (PL3.2.9)
- ROLL REGI METAL (PL3.2.10)
- KIT IIT ASSY SUB (PL10.9.99)
- ADF ASSY (PL10.10.1)
- KIT ADF FEED ROLL and SEPARATOR PAD (PL10.10.97)
Check
1 - 407
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. Go to step 5.
Use the Platen
Go to step 3. Mode or change
the original.
Go to step 4. End of work.
Replace the KIT
ADF ROLL and Replace the ADF
SEPARATOR ASSY. (Removal
PAD. (Removal 59/Replacement
57/Replacement 2)
4)
Turn on the power
of the air
conditioner, and
replace a new
Go to step 7.
dray and
recommended
paper, then go to
step 6.
End of work. Go to step 7.
Use the paper that
meets the
Go to step 9.
specifications,
then go to step 8.
End of work. Go to step 9.
No