Fip-1. 66 Paper Jam 075-102............................................................................................................. 1 - Dell 2135cn Service Manual

FIP-1. 66 Paper Jam 075-102
Step
Possible causative parts:
ROLL ASSY REGI (PL3.2.9)
ROLL REGI METAL (PL3.2.10)
SENSOR PHOTO (PL3.2.13)
ACTUATOR SSI (PL3.2.14)
SPRING REGI R M (PL3.2.24)
SPRING REGI L M (PL3.2.29)
HARN ASSY L SIDE (PL10.4.18)
PWBA MCU (PL10.7.7)
1 Was a paper pulled out from SSF forcibly?
Checking the printing
2 Reload a paper to SSF.
Does the error still occur when printing?
Checking after opening and closing the COVER ASSY
FRONT
Open and close the COVER ASSY FRONT, and then latch
3
correctly.
Does the error still occur when the power is turned OFF and
ON?
Checking the ROLL ASSY REGI and ROLL REGI METAL
for shape and operation
Remove the PHD UNIT once to check the followings.
Are ROLL ASSY REGI and ROLL REGI METAL seated
4
correctly?
Are they not contaminated and/or damaged, and rotated
smoothly?
Check these items by turning with your finger.
Checking the ROLL ASSY REGI and ROLL REGI METAL
for contacting
Is the ROLL REGI METAL surely contacted with the ROLL
5
ASSY REGI by the spring force on both sides of the ROLL
REGI METAL?
Check this item with your finger.
Checking the ACTUATOR SSI for shape and operation
Remove the CHUTE LOW (PL3.2.27) once to check the
6 operation.
Are the shape and operation of the ACTUATOR SSI
normal?
Checking the SSF No Paper Sensor (SENSOR PHOTO) for
operation
Remove the CHUTE LOW (PL3.2.27) once to check the
operation.
7 Does the number on the screen increase by one, when the
actuator (ACTUATOR SSI) of the SSF No Paper Sensor
(SENSOR PHOTO) is operated?
Checked by [Digital Input]-[DI-0] of [IOT Diag] in [Printer
Diag] of diagnosis.
Version 2 2008.03.31
Check
1 - 304
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. Go to step 3.
Go to step 3. End of work.
Go to step 4. End of work.
Clean or replace
Go to step 5. the defective
ROLL(s).
Replace the
SPRING REGI R
Go to step 6.
M and/or SPRING
REGI L M.
Reseat the
ACTUATOR SSI.
If broken or
Go to step 7.
damaged, replace
the ACTUATOR
SSI.
Replace the
PWBA MCU.
(Refer to Removal Go to step 8.
31/ Replacement
29.)
No