Clearing Lcd Error Messages - Dell 2355DN Service Manual

4.2.2 Clearing LCD Error Messages

Display message
Rear Cover is open
Close Rear Cover.
Data Read Fail
Check USB key
Data Write Fail
Check USB key
Device is not supported
Document Jam Check
Feeder
Toner Door is open
Close Toner Door
Duplex jam 0
Check Inside
Remove paper
& Open/Close Front Door
Duplex jam 1
Check Inside
Open Rear Door
File format is not
supported.
Fuser Door Open
Open Rear Door
Close Fuser Door
Fuser Error
Fuser Not Installed
Check Rear Door
Hub is not supported
In Idle State : [yyy]
Empty/Open
In Printing State : [yyy]
Empty/Open Load [zzz]
[xxx]
Service Manual
Alignment and Troubleshooting
Meaning
The rear door was opened while
duplex printing
Time expired while reading data.
Storing to the USB memory key failed. Check the available USB memory
Non USB mass storage device, such
as USB mouse, is connected with
USB memory port
The loaded document has jammed in
the DADF.
The front cover is not securely latched. Close the cover until it locks into
Paper has jammed during duplex
printing.
Paper has jammed during duplex
printing.
The selected file format is not
supported.
The fuser door is not securely latched. Open the rear door and close the
There is a problem in the fuser unit.
USB hub device is connected with
USB memory port.
The paper in the paper tray has run
out.
4-35
Suggested solutions
Close the rear door.
Try again.
space.
Remove the non USB mass storage
device from USB memory port.
Clear the document jam.
place.
Clear the jam. See "Clearing Paper
Jams"
Clear the jam. See "Clearing Paper
Jams"
Enter the correct item again.
fuser door until it locks into place. For
the location of the fuser door, see
"Clearing Paper Jams".
Unplug the power cord and plug it
back in.
If the problem persists, refer to the
troubleshooting for Fuser Error.
Remove the USB hub device from
USB memory port.
Load paper in the paper tray.