NEC Univerge SV8100 Features And Specifications Manual page 577

UNIVERGE SV8100
To Switch from Cordless to Desk Using Base Unit:
1. When Cordless II is associated with a terminal, use the Base Unit to switch between Cordless II
and the multiline terminal. Refer to Cordless II Base Unit Controls illustration on the next page.
2. Press Cordless to select D
-OR-
3. Press Desk to select multiline terminal.
 Switching must be accomplished while both terminals are idle.

A call in progress cannot be switched. When tried, it is dropped.

Switching held calls is not recommended because LED indications are not provided.

The Power LED and the applicable position LED are on to indicate selection.
Cordless II Base Unit Controls
To switch from Desk to Cordless using the Redial Key:
1. Verify that the Base Unit is in Desk mode.
2. Remove the battery.
3. Press and hold
4. Install the battery while holding these keys.
5. After the handset beeps one time, release the keys.
6. The handset is in Setup mode.
7. Press HOLD to display the current mode (Digital/Redial).
8. Press F2 and then HOLD.
term
Cordless II Terminal
D
term
Cordless II.
and on the handset.
#

Issue 12.0
2 - 547