NEC Univerge SV8100 Features And Specifications Manual page 451

UNIVERGE SV8100
Program
Program Name
Number
14-02-11 Analog Trunk Data Setup – Next
Trunk in Rotary if No Dial Tone
21-01-04 System Options for Outgoing
Calls – Dial Tone Detection Time
21-01-05 System Options for Outgoing
Calls – Disconnect Time When
Dial Tone Not Detected
21-01-06 System Options for Outgoing
Calls – Dial Pause at First Digit
Dial Tone Detection
Description/Comments
If Enabled, the system skips over
a trunk if dial tone is not detected.
This option pertains to calls placed
using Call Appearance (CAP)
Keys, Speed Dial, ARS, Last
Number Redial or Save Number
Dialed. It does not pertain to line
key or Direct Trunk Access calls.
If dial tone detection is Enabled,
the system waits this time for the
Telco to return dial tone. When the
time expires, the system assumes
dial tone is not present. To disable
this time (and have the system
wait continuously), enter 0.
If 14-02-11 is Enabled, the system
skips over a trunk if dial tone is not
detected. This option pertains to
calls placed using Speed Dial,
ARS, Last Number Redial or Save
Number dialed. It does not pertain
to line key or Direct Trunk Access
calls.
If Dial Tone Detection is Disabled,
the system waits this time before
sending dialed digits. If using Dial
Tone Detection, this time should
be set longer than the time set in
Program 21-01-05, otherwise, if
this time is set shorter than
Program 21-01-05, Dial Tone
Detection is satisfied and Program
21-01-05 is disregarded (not
used).
Assigned Data
1
0 = Disable
1 = Enable
(default = 0)
0~64800 (seconds)
(default = 5)
0~64800 (seconds)
(default = 3)
0~64800 (seconds)
(default = 1)
Issue 12.0
Level
2 3




2 - 421